Tervetuloa selaamaan verkkokauppaamme

Erikoisvahanpoistoaine Goaway 1L

Erikoisvahanpoistoaine Goaway 1L
Uusi tuote
Hintamme: 0.00 Euroa
Määrä:

Erikoisvahanpoistoaine kaikille vahatuille pinnoille syväpuhdistukseen /

Polish Remover

A super-quick polish remover for efficient and safe dissolving of tough coatings with many layers of polish of any type. For efficient removal of polish at restoring of floors. Does not require rinsing. Highly concentrated, very low dosage. Low pH value. Does not cause discolouration on floors. Suitable for use on linoleum floors.

pH value

ca 10.4 in concentrate.  
ca 9.9 in working solution (10%)  

Highly concentrated polish remover with quick dissolving effect. 
For quick and efficient removal of polish at restoring of floors. Highly suitable for removal of tough polish coatings with many layers of polish and for removal of polyurethane polish.No rinsing is required in normal conditions.

Product properties 
A super-quick polish remover for efficient and safe dissolving of tough coatings with many layers of old polish and of polyurethane polish. Very low dosage, highly concentrated. No rinsing is needed for lighter polish removal and normally clean floors - leaves no chemical residue. Goaway has a low pH value and does not cause discolouration. Suitable for use on linoleum floors without damaging the floor.

Dosing 
1 litre per 19 litres of cold water.

In especially difficult cases and for many layers of polish: 
1 litre per 9 litres of cold water.

For removal of polyurethane polish: 
1 litre per 4 litres of cold water. This working solution needs stirring prior to each application – this is necessary in order to ensure 100% efficiency.

Instructions for use 
Apply the working solution over very small areas to prevent drying - the product has a quick-dissolving effect and is quick-drying –, leave the working solution to act for up to 5 minutes. Scour thoroughly with a scrubber drier and a rough disc pad. Work with a scouring block in places inaccessible for the machine. Remove the dirty solution immediately with a wet vacuum cleaner! No rinsing is required for lighter polish removal and normally clean floors – only light damp mopping with clean water is needed prior to application of polish. In difficult cases and for many layers of polish, it may be necessary to repeat the removal process several times until the floor is polish-free – rinse such scoured floors immediately – one or two times with clean warm water. Remover the rinsing water as quickly as possible – use a wet vacuum cleaner. Leave the floor to dry well prior to base, top and surface treatment.

Note 
Avoid contact with painted surfaces.

Product information/Protection regulations 
See the material safety data sheet.

Storage 
Store in a cool place or at room temperature. 
Storage stability is at least 2 years in unopened packaging.

Transport packaging 
10 x 1 litre in a cardboard box.

Asiakasarvostelut

Tätä tuotetta ei ole arvosteltu. Ole ensimmäinen joka arvostelee tämän tuotteen.


Arvioi tämä tuote.